Fisher 1225-X Manuel d'utilisateur télécharger pdf (Page 18)

BATTERY REPLACEMENT

Two nine volt transistor batteries are located in separate

compartments at the rear of the housing. When it’s time to replace

batteries, always replace both of them.

1. To open, press gently down and out on the battery

door latch. The doors are hinged, do not attempt

to completely remove them.

2. Tilt the housing gently and the batteries will slide

out.

3. Insert the new batteries. Make sure the contact

end goes in ﬁrst and that you match the polarity

markings on the control housing.

4. To close, hook the lower edge of the battery door

over the inside of the battery compartment and

gently push.

5. Some battery brands may be slightly larger than

the original batteries, which will cause them to not

easily be removed.

Battery Replacement is simple; just pop the doors open,

slide the old batteries out and the new ones in.

Figure 8. Battery Replacement

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Fisher 1225-X Manuel d'utilisateur Page 18